Orthdent NITI+PEEK Matrix Ring Band Clamps – Sectional Matrix System

NITI frame, PEEK body and a silicone contact head

• Super-elastic NITI spring — moderate strength with enough give to seat quickly and keep steady separation.
• PEEK ring body — light and rigid, holding the matrix band without scratching enamel.
• Elastic silicone contact head — adapts to the tooth contour and grips the band so the contact point closes cleanly.
• Autoclavable at 135 °C — the whole ring withstands repeated high-pressure sterilization.

Three types for three clinical situations

Specifications

How to use

1. Place the sectional matrix band and wedge, then check that the contact point is closed.
2. Seat the ring with a matrix forceps so both silicone heads rest on the buccal and lingual surfaces.
3. Release slowly and confirm the band stays tight against the tooth before filling.

Frequently asked questions

Which type should I choose?

Short for premolars and low crowns, Tall for molars with high crowns, Wide Prep when the cavity is large or the axial angle is missing.

Can it be autoclaved?

Yes — the NITI spring, PEEK body and silicone head all withstand sterilization at 135 °C.

Is the matrix band included?

No — each pack contains one matrix ring. Bands and wedges are listed separately.

Related products

• Orthdent R5 sectional matrix clamp ring with PEEK clip and silicone pad
• Orthdent 3 m/roll stainless steel matrix bands
• Dental interdental wedges, autoclavable silicone
• All dental matrix bands

This product may be intended for use by a health care professional only.